KwikCut® 010|1.9mm (5)

MDT KwikCut® KC1 · 010 · 5

Crown cutterPFM crownsTungsten carbide

KwikCut – MDT’s crown cutter, 1.9 mm head

MDT’s KwikCut® KC1: a tungsten carbide crown cutter, 1.0 mm across with a 1.9 mm head, on a 19 mm FG standard shank. MDT list it with their metal and crown cutters.

This pack: MDT KwikCut® KC1 Tungsten Carbide Crown Cutter, FG, size 010, 1.9 mm head, 19 mm overall (Pack of 5, non-sterile)

Supplied clean, not sterile

MDT supply these burs "mechanically clean, but NOT sterile": clean and steam-sterilise them before first use and before each reuse – MDT’s instructions give 134°C with a 4-minute hold and 15 minutes’ drying. "Do not use worn-out or dull instruments."

What MDT say about it

›  MDT make their tungsten carbide burs "from a single piece of TC or from a TC tip brazed onto a surgical grade stainless-steel stem", and say "raw materials are selected carefully to ensure the maximum cutting tip hardness and neck strength of each bur to prevent the risk of breakage during use".

›  MDT: "MDT Crown Cutters are engineered for optimal efficiency in your hands during Porcelain-Fused-to-Metal (PFM) crown cutting."

›  Keep the bur moving and do not press hard – MDT warn that excessive pressure and a stationary bur both generate heat.

Complete the set

MDT KwikCut® KC1 · tungsten carbide crown cutter · 010 · 1.9 mm head · FG 19 mm · Pack of 5 · non-sterile · REF MDT-FG.TC0-KC1 · Made by MDT Micro Diamond Technologies, Israel