ZirconIT® Round End Taper 016|8.0mm (5)

MDT ZirconIT® ZRT · 016 · 5

Zirconia crownsCrown removalDiamond

ZirconIT® ZRT – MDT’s zirconia crown cutter

From MDT’s ZirconIT® ZRT burs, which MDT file under "Zirconia Crown Cutting": a round end taper diamond, 1.6 mm across with an 8 mm head, on a 21 mm FG shank.

This pack: MDT ZirconIT® ZRT Round End Taper Diamond Bur, FG, size 016, 8 mm head, 21 mm (Pack of 5, non-sterile)

What MDT say about ZirconIT® ZRT

MDT: "ZirconIT® ZRT Diamonds are engineered for removing zirconia crowns while offering better performance and less cutting time."

Supplied clean, not sterile

MDT supply these burs "mechanically clean, but NOT sterile": clean and steam-sterilise them before first use and before each reuse – MDT’s instructions give 134°C with a 4-minute hold and 15 minutes’ drying. "Do not use worn-out or dull instruments."

What MDT say about it

›  MDT’s catalogue sets their diamonds at 60% diamond exposure against 40% for others – "More Diamond Per Diamond®" – listing "stronger bonding" and "uniform diamond coating, including the tips" among the features, and "faster & cooler cutting/grinding" and "slower clogging" among the benefits.

›  MDT say their “Triton” coating process "more than doubles the strength of the diamond bonding to the tool", on "Swiss-made heat treated and ground Stainless Steel shanks".

›  Speed, from MDT’s instructions for a 1.6 mm head: 55,000–160,000 rpm recommended, never more than 450,000 rpm.

›  Keep the bur moving and do not press hard – MDT warn that excessive pressure and a stationary bur both generate heat.

Complete the set

MDT ZirconIT® ZRT · round end taper 016 · 8 mm head · FG 21 mm · Pack of 5 · non-sterile · REF MDT-Z198-016-ZRT · Made by MDT Micro Diamond Technologies, Israel