ZirconIT® Round 022|2.2mm (5)

MDT ZirconIT® ADJ · Round 022 · 5

Zirconia adjustmentPFMLithium disilicate

ZirconIT® ADJ – MDT’s zirconia adjustment diamond

From MDT’s ZirconIT® ADJ series, which MDT file under "Zirconia Adjustments": the Z001 round, 2.2 mm across with a 2.2 mm head, on a 21 mm FG shank.

This pack: MDT ZirconIT® ADJ Z001 Round Diamond Bur, FG, size 022, 2.2 mm head, 21 mm (Pack of 5, non-sterile)

What MDT say about ZirconIT® ADJ

MDT: "Improved specialty diamonds with bonding that allows precise and quick calibration and adjustments of Zirconia crowns. The new ZirconIT® ADJ series is also designed for PFM crowns, Lithium Di silicate and other Advanced Ceramic Crowns and Bridges adjustments."

Supplied clean, not sterile

MDT supply these burs "mechanically clean, but NOT sterile": clean and steam-sterilise them before first use and before each reuse – MDT’s instructions give 134°C with a 4-minute hold and 15 minutes’ drying. "Do not use worn-out or dull instruments."

What MDT say about it

›  MDT’s catalogue sets their diamonds at 60% diamond exposure against 40% for others – "More Diamond Per Diamond®" – listing "stronger bonding" and "uniform diamond coating, including the tips" among the features, and "faster & cooler cutting/grinding" and "slower clogging" among the benefits.

›  MDT say their “Triton” coating process "more than doubles the strength of the diamond bonding to the tool", on "Swiss-made heat treated and ground Stainless Steel shanks".

›  Speed, from MDT’s instructions for a 2.2 mm head: 40,000–120,000 rpm recommended, never more than 300,000 rpm.

›  Keep the bur moving and do not press hard – MDT warn that excessive pressure and a stationary bur both generate heat.

Complete the set

MDT ZirconIT® ADJ Z001 · round 022 · 2.2 mm head · FG 21 mm · Pack of 5 · non-sterile · REF MDT-Z001-022-ADJ · Made by MDT Micro Diamond Technologies, Israel