ProFile® 35/.06, 21mm (6)

ProFile® 35/.06 · 21 mm · pack of 6

Crown-downMid-root shapingFinal flaringContinuous rotation

ProFile 35/.06, 21 mm: shaping the middle third

A NiTi rotary file for the crown-down technique. Dentsply Sirona use the .06 files for the middle of the canal, and final flaring; this one is an ISO 35 tip on a constant .06 taper (6%).

This pack: ProFile® 35/.06 Rotary File, 21 mm (Pack of 6) · sterile, single use
Made by Dentsply Sirona · Maillefer Instruments Holding Sàrl, Ballaigues

›  Where it sits. In the brochure’s large-canal sequence it opens the .06 crown-down.
›  Safe design, in Dentsply Sirona’s words. A U-shaped flute with radial lands, and a non-cutting tip that “functions as a guide allowing penetration with a minimum pressure”.
›  How it is run. Constant speed between 150 and 350 rpm, a constant in-and-out movement and light apical pressure, never forced – ideally on a motor with both speed and torque control.

Working length is taken with an ISO 010–015 hand file before the apical files go to length; irrigate abundantly and often throughout, as the directions put it. They carry one warning worth passing on: ProFile contains nickel and should not be used where there is a known nickel allergy.

What we get asked

Which files do I need for a whole case?
The brochure sets out a sequence for small, medium and large canals: Orifice Shapers first, then the .06 and .04 files crown-down, then the .04 files at working length. It is in the download below.

How do I tell the tapers apart?
By the rings on the shank: one ring on the .04 files, two on the .06, three on the Orifice Shapers.

Complete the system

›  ProFile® brochure (PDF, 0.6 MB, Dentsply Maillefer) – the range and the small, medium and large-canal sequences.

ProFile® 35/.06 · ISO 35 · 6% taper · 21 mm · NiTi, continuous rotation · sterile, single use · Dentsply Sirona · REF A0345AD210035